TM 5-6675-348-13&P
Keep all personnel and equipment away from blade during calibration. Blade may move
suddenly, causing injury or death to personnel, or damage to equipment.
Do not disturb 130G grader while averaging sensors, or calibration will not be correct.
Left or right RESET Button must be held in for duration of calibration. Failure to comply
could result in improper 130G Grader performance.
NOTE
The system is requesting that
the upper limit be set.
↓ LIMIT should be displayed in
the left window.
WARM-UP should be displayed
in left window and AUTO in right
window.
System is requesting that lower
limit be set. Set lower limit, using
blade's manual lever, and lower
blade until approximately 1 to 3 in.
(2.54 to 7.6 cm) above ground.
(9)
Press RESET button (5) for side to be
calibrated. AVERAGING SENSORS will
flash across windows (4).
3-32
