TM 5-6675-348-13&P
Final section displayed in window
after MINIMUM has reached its
proper calibration number is
BALANCE. Correct calibration
number for this cycle will be 1.00%
0.01. If this number is not achieved,
the system will not finish calibrating.
Once BALANCE cycle has reached its
proper calibration number, SET ALL
will again be displayed in window.
(10) At this time, the Remote Offset Switch
located on the articulation control lever
can be released and valve calibration
complete for that side.
(11) Now it is time to calibrate the other side.
Prepare for this by using Blade Side Shift
Lever to move blade all the way to the
other side of grader. Repeat Steps (7)
through (10).
NOTE
When the final cycle of BALANCE has
completed, CALIBRATION COMPLETE
will display across both windows and
valve calibration will be complete.
(12) Exit Valve Calibration by positioning
OFF/ON/SET-UP switch (2) back to ON,
or center position.
3-34