TM 5-6675-348-13&P
NOTE
If Encoder Wire is released before
Encoder Web Belt is installed,
Steps (23) through (26) and
Steps (103) through (108) will
need to be repeated.
Install Encoder Web Belt rough
side out.
(109) Attach Encoder Web Belt (126) to
Encoder Wire (38) using three-link
chain (127).
(110) Attach Rivet end (128) of Web
Belt (126) to Belt Clip (124) at end of
Bucket Cylinder Ram (125).
c.
Tool Box.
(1) Measure and cut two hook and
pile strips (129) and apply to
stowage point (130) behind
Operator's seat (131).
(2) Remove protective paper from
two hook and pile strips (129)
and install tool box (132).
d. Follow-On Maintenance.
(1) Install Belly Plates (Para 4-30) as
required.
(2) Connect Batteries
(TM 5-3805-280-10).
(3) Remove Chocks
(TM 5-3805-280-10).
(4) Perform Bucket-ProTM System Calibration (Para 4-32).
END OF TASK
4-63