TM 5-6675-348-13&P
BLADE PRO MOTOR GRADER CONTROL SYSTEM PMCS
SECTION II.
Preventive Maintenance Checks and Services (PMCS) means systematic caring for, inspecting, and servicing
equipment to keep it in good condition and to prevent breakdowns. As a Blade Pro Motor Grader Control
System Operator, your mission is to:
Be sure to perform your PMCS each time you operate the Blade Pro Motor Grader Control
a.
System. Always do your PMCS in the same order so it becomes a habit. Once you've had some
practice, you'll quickly spot anything wrong.
Do your Before PMCS just before you operate the Blade Pro Motor Grader Control System. Pay
b.
attention to WARNINGS, CAUTIONS, and NOTES.
Do your During PMCS while you operate the Blade Pro Motor Grader Control System. Pay attention
c.
to WARNINGS, CAUTIONS, and NOTES.
Do your After PMCS right after operating the Blade Pro Motor Grader Control System. Pay attention
d.
to WARNINGS, CAUTIONS, and NOTES.
e.
Do your Weekly PMCS once a week.
f.
Use DA Form 2404 or DA Form 5988-E (Equipment Inspection and Maintenance Worksheet) to
record any faults that you don't immediately fix.
PMCS PROCEDURES.
a.
PMCS Tables (Table 3-4., Table 3-5., and Table 3-7.) list inspections and care required to keep
your Blade Pro Motor Grader Control System in good operating condition. These tables are set
up so you can do Before and After PMCS while walking around the Blade Pro Motor Grader
Control System.
b.
The "Interval" column tells you when to do a certain check or service.
c.
The "Procedure" column tells you how to do required checks and services. Carefully follow these
instructions.
The "Not Fully Mission Capable If " column tells you when your Blade Pro Motor Grader
d.
Control System is nonmission capable and why the Blade Pro Motor Grader Control System
cannot be used.
e.
When something looks wrong that you cannot fix, write down the problem on your
DA Form 2404 or DA Form 5988-E. Immediately report the problem to your supervisor.
f.
When you do your PMCS, you will always need a rag or two. Following are checks that are
common to the entire Blade Pro Motor Grader Control System.
