TM 5-6675-348-13&P
SET CUT DEPTH.
NOTE
A cut depth (or depth of excavation)
is the distance between bench
elevation and target grade line
(solid line) on Graphic Display.
Positive depth cuts are above
reference elevation and negative
depth cuts are below reference
elevation.
Majority of normal excavating uses
negative depth cuts.
(1)
Press MODE button to access MAIN
MENU.
(2)
Point menu arrows to SET CUT DEPTH
mode using Up and Down (↑↓) buttons.
(3)
Press ENTER button to confirm selection.
(4)
Current CUT DEPTH appears in lower left
corner of screen after "E." An instruction
window SET CUT DEPTH appears in the
center of the screen.
NOTE
Cut depth value is the vertical
distance from benchmark eleva-
tion to bottom of trench or
basement.
To restore default cut depth of
0.00 ft, simultaneously press Up
and Down (↑↓) buttons.
(5)
Adjust displayed elevation value to correct
DEPTH OF CUT using Up and Down (↑↓)
buttons.
(6)
Press ENTER button to confirm selected DEPTH OF
CUT value. Normal Operating Screen returns.