TM 5-6675-348-13&P
To prevent damage to equipment, the
Circle Rotation Sensor Cable must be
secured to hydraulic lines with cable
ties approximately every 6 in.
(15.2 cm).
NOTE
Leave approximately 2 in. (5.1 cm) of
slack in Rotation Sensor Cable for
(24) Route Circle Rotation Sensor
Cable (21) with existing hydraulic
lines to front of 130G Grader.
NOTE
Gooseneck Panels for both sides of the
130G Grader are removed the same.
The left side is shown.
(25) Remove eight bolts (22) and
washers (23).
(26) Remove Gooseneck
Panels (24) and (25)
and Float Valve (26) from
Gooseneck (27).
(27) Route Circle Rotation Sensor
Cable (21) under Gooseneck
Panel (28).
Do not cable tie Circle Rotation Sensor
Cable Service Loop inside the
Gooseneck. Failure to comply could
result in damage to 130G Grader.
NOTE
Leave approximately 18 in. (46 cm)
hanging past 130G Grader's Gooseneck
Panel's rear mounting location.
(28) Create a Service Loop (29) of the extra
Circle Rotation Sensor Cable (21) inside
the Gooseneck (27).
(29) Route Circle Rotation Sensor Cable (21)
with existing hydraulic lines in Gooseneck (27).
3-91
