TM 5-6675-348-13&P
AUTOMATIC CROSS-SLOPE AND MANUAL ELEVATION.
a.
General Information.
Automatic Cross-Slope and Manual Elevation allows the Operator to manually control the
elevation on the left side of the blade and the cross-slope on the right side of the blade is automatically
controlled. Cross-slope and manual elevation setup can be applied on projects that will use existing
elevations but require a cross-slope for drainage (e.g., tank trails and dirt road upgrades).
b. Setting Up the Blade Pro Motor Grader Control System.
(1)
Set OFF/ON/SET-UP switch (1) to ON position.
NOTE
If previous slope was 0.0, no slope symbol (<) will be shown.
(2)
Set Mode switch (2) to left position.
Left Display
Right Display
I 0.00
> 0.1%
(3)
Enter desired cross-slope in right display window by using right Increase/Decrease switch (3).
Left Display
Right Display
I 0.00
< 2.0%
(4)
Change blade slope direction switch (4) to match desired slope, if required.
Left Display
Right Display
I 0.00
< 0.0%