ORGANIZATIONAL, DIRECT AND GENERAL SUPPORT AND
DEPOT MAINTENANCE REPAIR PARTS
AND SPECIAL TOOL LISTS
Section I. INTRODUCTION
1. General
2. Explanation of Repair Parts, Tools Lists,
and Prescribed Load listing (Table 1).
a. This appendix lists repair parts and special
tools for organizational, direct and general sup-
a. Source Codes. This column is subdivided
port, and depot maintenance. It indicates the
into four columns. The titles and information
provided in each column are as follows:
quantity of repair parts required to be stocked
by organizational maintenance as their pre-
(1) Materiel. This column is left blank.
scribed load. It indicates the guide quantity
For identification of agencies assigned
factors to be used for initial repair parts
supply responsibility for parts, refer
stockage by direct and general support, and
to appropriate Federal and Depart-
recommends quantities of repair parts for
ment of Army supply catalogs.
depot maintenance. Information and data con-
(2) Source. The selection status and
tained herein serve as requisitioning reference
source of supply for each part are
material, and as a guide to determine stockage
indicated by one of the following code
quantities of repair parts.
symbols:
b. Price information for stock-type repair
(a) P-applied to high-mortality repair
parts may be obtained from applicable Federal
parts which are stocked in or sup-
Supply Catalogs and/or Supply Management
plied from the Army supply sys-
Data and Price List (ML) of the Department
tem, and authorized for use at in-
of Defense Supply agencies.
dicated maintenance categories.
c. Repair parts lists are arranged as follows:
(b) X1-applied to repair parts which
are not procured or stocked, the
(1) Individual parts and major assemblies
requirement for which will be sup-
are listed alphabetically by item name
plied by use of next higher assem-
within the functional groups.
bly or components.
(2) Assembly components and subassem-
(c) X2-applied to repair parts which
blies are indented and listed alpha-
are not stocked. The indicated
betically by item name under major
maintenance category requiring
assemblies.
such repair parts will attempt to
(3) Bulk material and parts peculiar with
obtain them through cannibaliza-
more than one application are listed
tion; if not obtainable through
in functional groups 9501 and 9901
cannibalization, such repair parts
respectively.
will be requisitioned with support-
d. Allowances are based on 700 hours opera-
ing justification through normal
supply channels.
tional per year.
AGO 10139A
