TM 5-6665-202-13
2-4. Reinstallation After Movement
NOTE
If the mine detecting set is accidently dropped or
Refer to paragraph 2-2 for setting-up instructions after
subjected to hard bumps, it should be thoroughly
movement.
inspected for damage before it is operated.
Section III. CONTROLS AND INSTRUMENTS
2-6. Controls and Instruments
2-5. General
This section describes, locates, illustrates, and furnishes
Refer to figure 2-3 for a complete description of the
the operator, or organizational maintenance personnel
controls.
sufficient informaiton about the various controls for proper
operation of the mine detector set.
Figure 2-3. Controls.
Section IV. OPERATION UNDER USUSAL CONDITIONS
2-8. Starting
2-7. General
a. Preparation for Starting.
a. The instructions in this section are published for the
information and guidance of the personnel responsible for
(1) Perform the setting-up instructions (para 2-2).
the operation of the AN/PSS-11 mine detector set.
(2) Perform the daily preventive maintenance
b. The operator must know how to perform every
services (para 3-2).
operation of which the mine detector set is capable. This
section gives instructions on starting, operating, and
(3) Position headset on head.
stopping the mine detector set. Operation under unusual
environmental conditions is also explained. Since terrain
(4) Attach receiver and transmitter assembly (fig.
and weather are so variable, the operator may have to adapt
1-1) to pistol belt.
stated procedures to meet actual field conditions.