TM 5-6675-348-13&P
ADDITIONAL MAINTENANCE INSPECTIONS.
Additional maintenance inspections are required for the following reasons:
a.
Prolonged storage. Inspect 1145-2 Laser Transmitter, 1275 Laser Receiver, and Elevating Base
and Tripod system components that have been stored for a period of 3 months or more.
b.
Initial preparation upon receipt.
c.
Preparation for storage.
LEAKAGE CLASSIFICATION AND DEFINITION.
There are no fluid reservoirs on 1145-2 Laser Transmitter and Elevating Base and Tripod system.
GENERAL LUBRICATION INSTRUCTIONS.
Do not look into 1145-2 Laser Transmitter for a long period of time. Failure to comply may
cause injury to personnel.
Intervals. Intervals (on-condition or hard time) and related man-hour times are based on normal
a.
operation. Man-hour time specified is time needed to do all services prescribed for a particular interval.
Change hard-time interval when operating equipment under adverse operating conditions, including
longer-than-usual operating hours. The calendar interval will be extended during periods of low
activity. When extended, adequate preservation precautions must be taken. Hard-time intervals must
be applied during warranty period. Intervals shown in this section are based on calendar and hourly
times.
PMCS COLUMN ENTRY EXPLANATION.
Item No. Column. Checks and services are numbered in interval order showing a walk-around
a.
sequence around the 1145-2 Laser Transmitter and Elevating Base and Tripod system. Use these
numbers in the "Item No." column on DA Form 2404 or DA Form 5988-E when recording faults that
you don't immediately fix.
Interval Column. This column indicates when the lubrication, check, and/or service should be
b.
performed.
Location, Item to Check/Service Column. Underlined items listed in this column are divided into
c.
groups indicating the portion of the equipment of which they are a part (e.g., brakes, fuel, and engine).
Under these groupings, a few common words are used to identify the specific item being checked.
Procedure Column. This column contains procedures required to perform checks and services.
d.
Not Fully Mission Capable If Column. This column contains criteria that cause the equipment to be
e.
classified as NOT READY/AVAILABLE because of an inability to perform its primary mission. An
entry in this column will:
(1)
Identify conditions that make equipment not available for readiness reporting purposes.
(2)
Deny use of equipment until corrective maintenance has been performed.
