TM 5-6675-348-13&P
CUT/FILL.
NOTE
CUT/FILL option allows the setup on
Graphic Display a secondary dotted grade
line above or below main solid finished-
grade line. CUT/FILL line can be used to
control bedding-layer thickness, top-of-
pipe location, or a stepped trench for a
catch basin. Use the following steps to set
CUT/FILL line:
(1)
Press MODE button to access MAIN
MENU.
(2)
Point menu arrows to CUSTOMIZE
menu, using Up and Down (↑↓) buttons.
(3)
Press ENTER button to confirm selection.
NOTE
ARE YOU SURE? window appears
on Graphic Display.
Using Up and Down (↑↓) buttons, select
(4)
NO if you want to disable CUT/FILL and
return to CUSTOMIZE menu, or select
YES to continue.
NOTE
If you chose CUT/FILL, a CUT/FILL
dimension window appears.
A positive CUT/FILL value generates a
dotted line above solid finished-grade line.
A negative CUT/FILL value generates a
dotted line below solid finished-grade line.
To protect against overcut in areas having
a lot of underground facilities, a negative
CUT/FILL layer can be used in conjunction
with overcut alarm (refer to DEADBAND)
as a maximum allowable over-dig line.
(5)
Enter layer thickness you want, using Up and
Down (↑↓) buttons.
(6)
After selecting value wanted, press ENTER
button to return to CUSTOMIZE menu.
To exit menu, press Up and Down (↑↓) buttons to highlight EXIT and press ENTER button, or
(7)
press MODE button.
