TM 5-6675-348-13&P
NOTE
The aid of an assistant is required for
Step (191).
Measurement is adjusted by movement
of Slope Sensor Mounting Plate.
(191) With the aid of an assistant, square Slope
Sensor Mounting Plate (152) to
Moldboard (144) using straightedge, level,
and measuring tape until distance between
straightedge and Moldboard (144) is equal
within 1/4 in. (0.64 cm) on both sides.
NOTE
Step (192) applies to both sides of vehicle.
(192) Chisel mark on 130G Grader's Rotation
Circle (155).
(193) Remove Slope Sensor (154) from Slope
Sensor Mounting Plate (152).
3-119