TM 5-6675-348-13&P
(133) Cut approximately 1 1/4-in. (3.2 cm) slot,
1 in. (2.54 cm) wide and 1/2 in. (1.3 cm)
deep, in left side of Stack Valve Cover (93).
(134) From under cab, route Operator Cable (36)
over hydraulic lines, under floorboard, and
into cab.
(135) Install right side of Stack Valve Cover (93),
three washers (92), and screws (91) over
Operator Cable (36).
NOTE
For ease of installation, remove only
one screw in column at a time. Work
from floorboard up column.
(136) Remove screws (94) from column (95).
(137) Install Operator Cable (36), Loop
Clamps (96), and bushings (97) on
column (95) with screws (94).
(138) Cable tie Operator Cable (36) to
Steering Column Release Lever (98).
3-106