TM 5-6665-202-13
Section V. Operation Under Unusual Conditions
2-11. Operation in Temperatures Below 40 F.
NOTE:
INSTALL BATTERY ADAPTER COMPONENTS
BY TURNING THEM CLOCKWISE. REMOVE
COMPONENTS BY TURNING THEM
The temperature of the battery must be kept at 40 F. or
COUNTERCLOCKWISE.
above. To accomplish this, the operator can wear the
NOTE:
TIGHTEN BATTERY CASE ADAPTER AND
transmitter-receiver assembly under his outer clothing, or
TUBE ADAPTER UNTIL SNUG. PREFORMED
use the battery adapter. Refer to figure 2-9 for instructions
PACKING MUST BE SUFFICIENTLY
on installing and removing the battery adapter. After the
COMPRESSED TO FORM WATERPROOF SEAL.
battery adapter is installed in the receiver and transmitter
assembly, place the battery tube inside the clothing so that
body heat of the operator will keep the battery warm and
allow the mine detector set to function properly. Allow a
2-minute warmup time before operating set. When the
mine detector set is taken inside a heated building after it
has been exposed to extreme cold, moisture will form on
the metallic surfaces. Wipe all moisture from the
equipment before securing in the case.
2-12. Operation in Dusty or Sandy Areas
When operating the mine detector set in dusty or sandy
area, special precautions should be taken to keep dust and
dirt out of the equipment. Make sure the latches that secure
the case on the transmitter are locked.
U n d e r Rainy or Humid
REMOVE BATTERY FROM RECEIVER AND
STEP 1.
Conditions
INSTALL BATTERY CASE ADAPTER IN
STEP 2.
When operating the mine detector set under rainy or humid
RECEIVER AND TRANSMlTTER ASSEMBLY.
conditions, keep the set wiped dry as much as possible.
REMOVE BATTERY TUBE FROM TUBE
STEP 3.
Make sure the two latches on the sides of the transmitter are
ADAPTER, INSTALL BATTERY IN BATTERY
TUBE, INSERTING POSITIVE (PLUS) END
secured. Make sure all components are tightly sealed.
FIRST. INSTALL BATTERY TUBE ON TUBE
Check all cables for loose connections. After operation in
ADAPTER.
rainy or humid conditions, store the detector set in a warm,
BATTERY ADAPTFR REMOVAL:
dry area to allow the moisture to evaporate.
REMOVE BATTERY CASE ADAPTER FROM
STEP 1.
RECEIVER AND TRANSMITTER ASSEMBLY.
REMOVE BATTERY TUBE FROM TUBE
STEP 2.
ADAPTER, TILT BATTERY TUBE ON TUBE
ADAPTER.
2-14. Operation in Salt Water Areas
INSTALL BATTERY IN RECEIVER AND
STEP 3.
Salt water air and spray are highly corrosive to many parts
NOTE:
STORE ASSEMBLED BATTERY ADAPTER IN
of the metallic mine detector set. Wipe the set dry as often
TOP OF CARRYING CASE.
as possible to avoid corrosion. After operation is
completed, rinse any salt water off the detector with fresh
water, and dry thoroughly. Make sure all components are
tightly sealed and cable assembly bushings are tight.
2-10
Change 3