TM 5-6675-348-13&P
(46) Position Dual-Axis Tilt Sensor Mounting
Bracket (60) 10-1/2 in. (26.7 cm) from
Bulkhead (54) and 1/4 in. (0.64 cm) from
edge of platform (61).
(47) Mark location for mounting holes (62).
(48) Drill two 5/16-in. (8 mm) holes (62).
(49) Discard Slope Sensor Mounting
Bracket (60).
NOTE
Place Electrical Connector toward cab
when Dual-Axis Tilt Sensor is
installed.
(50) Install Dual-Axis Tilt Sensor (63) with
two bolts (64), lockwashers (65), and
flat washers (66).
(51) Tighten bolts (64).
4-51