Figure 29. Carrying case, disassembly and reassembly.
1
Collar
10
Hook (2 rqr)
19 Washer (3 rqr)
2
Screw (6 rqr)
11
Pin (2 rqr)
20 Knob (3 rqr)
3
Belt
12
Hook
21 Screw (spec) (3 rqr)
4
Rivet (6 rqr)
13
Plate
22 Rubber gasket
5
Washer (6 rqr)
14
Base
23 Desiccant container
6
Pin (2 rqr)
15
Pin (3 rqr)
24 Screw (6 rqr)
7
Setscrew (2 rqr)
16
Screw pin (3 rqr)
25 Eyepiece container (2 rqr)
8
Setscrew (2 rqr)
17
Lever (3 rqr)
26 Screw (2 rqr)
9
Lever (2 rqr)
18
Washer (3 rqr)
27 Cover
traces of rust and repaint where
b. Base.
necessary.
(1) Removal. Remove the base (par. 7).
(g) Straighten minor dents or bends in
(2) Disassembly. Refer to figure 29 and
the hood. Seal all cuts or holes in
disassemble the base.
the
hood.
Repaint
where
(3) Cleaning, inspection, and repair.
necessary.
(a) Clean all metal parts with an
(h) Replace all defective parts that
approved cleaning solvent and dry
cannot be repaired.
thoroughly.
Brush
threaded
(4) Reassembly. Refer to figure 29 and
surfaces free of any foreign matter.
reassemble the hood.
(5) Installation. Install the hood (par. 7).
AGO 5078A 40