TM 10-4510-206-14
B.
WATER HOSE ASSEMBLY.
Five 1-inch (25.4 mm) ID hoses, each measuring 7
1/2-feet (2.29 meters).
The hoses interconnect the water pump assembly,
water heater assembly , mixing valve assembly, and three shower stand
assemblies.
C.
MIXING VALVE ASSEMBLY. The mixing valve assembly mixes hot water from
the water heater and cold water from the water pump and water source
to provide heated water to the shower stands at approximately 105°F
(40.5°C).
D.
WATER HEATER.
The water heater is a self-contained, liquified
fuel-fired boiler that heats water supplied by the water pump. The
major subassemblies or components that make up the water heater are
water vessel, burner assembly, blower assembly, control box assembly,
sight glass assembly, and transformer and ignition cables.
E.
DRUM FILL ADAPTER ASSEMBLY.
The drum fill adapter assembly can be
used with either a 55-gallon (208.2 liter) fuel drum or a 5-gallon (18.9
liter) gasoline can.
Fuel level can be visually checked and refueled
without disconnecting fuel lines.
F.
FUEL CONTAINER.
The fuel container may be either a 55-gallon (208.2
liter) fuel drum or a 5-gallon (18.9 liter) gasoline can.
G.
FUEL FEED AND RETURN HOSE ASSEMBLIES.
Flexible hoses provide supply
and return fuel between the fuel storage container and fuel pump
assembly on the water heater.
H.
POWER CABLE ASSEMBLY. The power cable assembly consists of two cables
that extend from the power source to the Bath Unit.
The short cable
connects to a 208 V, 3-phase power source.
The long cable connects co
the short cable, water heater, and water pump.
1.
WATER PUMP-HEATER HOSE ASSEMBLY. One 1 1/2-inch (38.1 mm) ID hose
measuring 6-feet (1.52 meters) connects the water pump to the water
heater.
J.
WATER PUMP.
The water pump draws water from the water source through
the intake hose and in-line strainer and supplies it through a discharge
line to the water heater.
K.
SUCTION HOSE ASSEMBLY.
One 1-inch (25.4 mm) ID hose measuring 25 feet
(7.62 meters) connects the water supply to the water pump.
L.
SUCTION STRAINER ASSEMBLY.
The suction strainer assembly is connected
to the suction hose assembly.
It prevents leaves and debris from
entering the water system.
Change 1
1-3
