If power source does not have a female connection
fitting the male end of the long power cable, then the
short power cable must be wired to the source by
organizational maintenance personnel qualified to
perform electrical installations. Refer to drawing
number 6-1-8222, chapter 6, section III.
procedures in paragraph 2-7.1 are followed to verify
correct wiring connections.
Connect cable assembly (31) to water heater (7), water pump (6) and to
Use only specified fuel.
Failure to do so may result in
injury to personnel or equipment.
Lack of lubrication may cause pump damage when straight
gasoline is used as fuel.
To avoid failure, 1 quart of
oil must be mixed with each 5 gallons of gasoline used.
(See paragraph 3-1.)